Skip to Content

Kia Ora, Hello!

 This is a peer-to-peer forum — not live tech support.

Sign up

You need to be registered to interact with the community.
All Posts People Badges
Tags (View all)
E11 Getting-Started
About this forum
This question has been flagged
E11
1 Reply
595 Views
Avatar
Annette Eggers

I’ve bled Line A and run a manual cycle, but the E11 fault still keeps coming back after a few hours. Grease lines are full, and the reservoir is topped up.

Anyone seen this before? Could it be a faulty pressure switch, or something else?


Avatar
Discard
Avatar
Annette Eggers
Author

Just adding a follow-up: this ended up being air trapped in Line A. We’d bled it manually but didn’t purge the pump properly.

Fixed it by:

  • Re-filling the reservoir fully
  • Running a few manual cycles
  • Bleeding again at the furthest metering unit

Also worth checking the pressure switch connection — we’ve seen them vibrate loose in field units.


Avatar
Discard